| ürün varış noktası |
Asenkron motorlar |
| set başına miktar |
1'li set |
| EMC filtresi |
EMC filtresi olmadan |
| soğutma türü |
Entegre fan |
| tedarik frekansı |
50/60 Hz +/- 5 % |
| iletişim portu protokolü |
Modbus |
| bağlantı tipi |
Modbus için RJ45 (ön yüzünde) |
| fiziksel arayüz |
Modbus için 2 telli RS 485 |
| şanzıman çerçevesi |
Modbus için RTU |
| iletim hızı |
4800 bit/sn
9600 bit/sn
19200 bit/sn
38400 bit/sn |
| adres sayısı |
1…247 Modbus için |
| iletişim hizmeti |
Read holding registers (03) 29 words
Write single register (06) 29 words
Write multiple registers (16) 27 words
Read/write multiple registers (23) 4/4 words
Read device identification (43) |
| line current |
22.4 A |
| apparent power |
17.8 kVA |
| prospective line Isc |
5 kA |
| continuous output current |
17 A at 4 kHz |
| maximum transient current |
25.5 A for 60 s |
| power dissipation in W |
203.87 W at In |
| speed drive output frequency |
0.5…400 Hz |
| nominal switching frequency |
4 kHz |
| switching frequency |
2...12 kHz adjustable |
| speed range |
1…20 |
| transient overtorque |
170…200 % of nominal motor torque depending on drive rating and type of motor |
| braking torque |
Up to 150 % of nominal motor torque with braking resistor at high inertia
Up to 70 % of nominal motor torque without braking resistor |
| asynchronous motor control profile |
Energy saving ratio
Energy saving ratio
Quadratic voltage/frequency ratio |
| motor slip compensation |
Adjustable
Adjustable |
| output voltage |
380...460 V three phase |
| electrical connection |
Terminal, clamping capacity: 6...10 mm² (L1, L2, L3, PA/+, PB, U, V, W) |
| tightening torque |
2.2…2.4 N.m |
| insulation |
Electrical between power and control |
| supply |
Internal supply for reference potentiometer: 5 V (4.75…5.25 V)DC, <10 mA with overload and short-circuit protection
Internal supply for logic inputs: 24 V (20.4…28.8 V)DC, <100 mA with overload and short-circuit protection |
| analogue input number |
1 |
| analogue input type |
Configurable current AI1 0...20 mA 250 Ohm
Configurable voltage AI1 0...10 V 30 kOhm
Configurable voltage AI1 0...5 V 30 kOhm |
| discrete input number |
4 |
| discrete input type |
Programmable LI1...LI4 24 V 18...30 V |
| discrete input logic |
Negative logic (sink), > 16 V (state 0), < 10 V (state 1), input impedance 3.5 kOhm
Positive logic (source), 0...< 5 V (state 0), > 11 V (state 1) |
| sampling duration |
10 ms for analogue input
20 ms, tolerance +/- 1 ms for logic input |
| linearity error |
+/- 0.3 % of maximum value for analogue input |
| analogue output number |
1 |
| analogue output type |
AO1 software-configurable voltage: 0...10 V, impedance: 470 Ohm, resolution 8 bits
AO1 software-configurable current: 0...20 mA, impedance: 800 Ohm, resolution 8 bits |
| discrete output number |
2 |
| discrete output type |
Logic output LO+, LO-
Protected relay output R1A, R1B, R1C 1 C/O |
| minimum switching current |
5 mA at 24 V DC for logic relay |
| maximum switching current |
2 A at 250 V AC on inductive load cos phi = 0.4 L/R = 7 ms for logic relay
2 A at 30 V DC on inductive load cos phi = 0.4 L/R = 7 ms for logic relay
3 A at 250 V AC on resistive load cos phi = 1 L/R = 0 ms for logic relay
4 A at 30 V DC on resistive load cos phi = 1 L/R = 0 ms for logic relay |
| acceleration and deceleration ramps |
S
S
U |
| braking to standstill |
By DC injection, <30 s |
| koruma türü |
Şebeke aşırı gerilimi
Şebeke düşük gerilimi
Çıkış fazları ve toprak arasında aşırı akım
Aşırı ısınma koruması
Motor fazları arasında kısa devre
Üç fazlı sistemde giriş faz kaybına karşı koruma
Sürekli I²t hesaplamasıyla tahrik yoluyla termik motor koruması |
| frekans çözünürlüğü |
Analog giriş: A/D dönüştürücü, 10 bit
Ekran birimi: 0,1 Hz |
| zaman sabiti |
Referans değişikliği için 20 ms +/- 1 ms |
| işletme pozisyonu |
Dikey +/- 10 derece |
| yükseklik |
232 mm |
| Genişlik |
150 mm |
| derinlik |
171 mm |
| net ağırlığı |
3,7 kg |